Installing a Brick Paver Walkway or Brick Crusher Machine

The usage of Setting up a Brick Paver Walkway or Bricks Pavers or Pavers to create a pathway or patio area matches a home in a manner in which is unequaled. It includes a level of quality and sophistication to a home entrance that can not be achieved with either concrete or asphalt. Brick and Pavers also come in several colors and shapes enabling special color schemes and patterns to be achieved. In addition, setting up a Brick or Paver sidewalk does not always need a pro. With some fundamental knowledge and a relatively basic pathway strategy, a house owner can undertaking such a task.

The key to installing a Brick or Paver Walkway is to first effectively prepare the area where the bricks/pavers are to be installed. In addition, string lines ought to be strung on each side of the pathway.
As soon as the area has been dug down, 3/4" gravel stone should be laid in and tamped down securely. Then 2" of sand, or stone dust ought to be spread over the gravel. Again the sand/stone dust should be tamped down. Stone dust is chosen. The height in between the tamped down sand and the stringline need to equate to the density of the brick or paver.

Now that you have a steady base, position a 1" pipeline or ledger board the length of the walkway on either side of the sidewalk. Then using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will create a level area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Install a work on both sides of the ready location. These strips will serve as your pathway border and assistance to preserve the integrity and shape of the walkway. You can get these plastic strip borders at the majority of house improvement shops. The strips must be anchored down with 12" galvinized nails. You ought to sink these nails into the ground and through the strips every foot.

The key to read more laying the bricks/pavers is to make sure that they interlock with each other. Always stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will once again help preserve the stability of the pathway.

When building the walkway, inevitably bricks/pavers will require to be cut or divided. Unless you wish to purchase or lease a costly wetsaw, I would suggest purchasing a basic brick/paver splitter. It is basically a sculpt with a wide end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the area where you wish to break the brick. Then using a hammer strike the butt end of the sculpt securely. You may need to do this a number of times. You may also desire to turn the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within a couple of strikes the brick/paver should break cleanly. If your walkway has curves you will require to buy/rent a wetsaw.

After installing the bricks, develop the outdoors edges with additional sand, and after that shovel in the topsoil and pack down securely.
Spread stone dust over the new sidewalk and sweep into the fractures. This will complete the interlocking of the bricks and assist to remove any weed growth.


In addition, setting up a Brick or Paver sidewalk does not necessarily require a pro. The key to installing a Brick or Paver Walkway is to first correctly prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, position a 1" pipe or ledger board the length of the pathway on either side of the sidewalk. These strips will act as website your sidewalk border and aid to preserve the integrity and shape of the pathway. Inevitably bricks/pavers will require to be cut or split when constructing the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *